Firmware Development - STM32 Primer2
Required skills: C/C++, Electronics, Microcontroller, Scientific Research
INTRODUCTION
The purpose of this document is to define the high level requirements for a firmware
development project of a sensor data collection system based on STM32 Primer 2 and ST
MEMS sensors.
This project description intends to define a design for a complete firmware, ready-to-use
for demonstration, operating on a system built from STM32 Primer2 and MEMS
accelerometers. The accelerometers are low-power 3-axis linear accelerometers with
digital output. The foreseen firmware needs to run an STM32 Primer2 device connecting
the sensing elements via an I2C interface, capable of translating information from a
numbeDesign Principles
This section provides the design principles with reasons driving these principles.
- Simplicity
-- Very simple, if possible the simplest solutions are preferred.
- I2C Bus
-- For the communication between the STM Primer The usage of I2C bus is flexible printed circuit board is required.
- Portability
The preference it to create a firmware, which is portable between STM32 and ST7
microcontrollers (both present on the STM32 Primer2 development platform)
Scope of Work
The following activities are in scope:
- Connection of Sensor
-- via Add-On Module [5] or
-- via breakout boards of MEMS sensors connecting to the E14 extension
connector of STM32 Primer2, similar to [6] (Please note, that this is a
different type of MEMS, although suitable for I2C integration development)
- Firmware development
- Testing
SCOPE
The following activities are out of scope:
- Application development
The following activities are limited to the necessary extent:
- Electronic advice, design and verification with regards to SMT32 Primer2
The following activities may be extended to the necessary extent:
- Advice on electronic design and verification with regards to replacing SMT32 Primer 2 with SMT32 Primer1
- Advice on electronic design and verification with regards to replacing the SMT32
Primer2 with an Atmel AVR based solution
... DETAILED PROJECT DESCRPTION ATTACHED
Additional files submitted:
STM32+Primer2+Fimware+Develpment++PA1.pdf
The purpose of this document is to define the high level requirements for a firmware
development project of a sensor data collection system based on STM32 Primer 2 and ST
MEMS sensors.
This project description intends to define a design for a complete firmware, ready-to-use
for demonstration, operating on a system built from STM32 Primer2 and MEMS
accelerometers. The accelerometers are low-power 3-axis linear accelerometers with
digital output. The foreseen firmware needs to run an STM32 Primer2 device connecting
the sensing elements via an I2C interface, capable of translating information from a
numbeDesign Principles
This section provides the design principles with reasons driving these principles.
- Simplicity
-- Very simple, if possible the simplest solutions are preferred.
- I2C Bus
-- For the communication between the STM Primer The usage of I2C bus is flexible printed circuit board is required.
- Portability
The preference it to create a firmware, which is portable between STM32 and ST7
microcontrollers (both present on the STM32 Primer2 development platform)
Scope of Work
The following activities are in scope:
- Connection of Sensor
-- via Add-On Module [5] or
-- via breakout boards of MEMS sensors connecting to the E14 extension
connector of STM32 Primer2, similar to [6] (Please note, that this is a
different type of MEMS, although suitable for I2C integration development)
- Firmware development
- Testing
SCOPE
The following activities are out of scope:
- Application development
The following activities are limited to the necessary extent:
- Electronic advice, design and verification with regards to SMT32 Primer2
The following activities may be extended to the necessary extent:
- Advice on electronic design and verification with regards to replacing SMT32 Primer 2 with SMT32 Primer1
- Advice on electronic design and verification with regards to replacing the SMT32
Primer2 with an Atmel AVR based solution
... DETAILED PROJECT DESCRPTION ATTACHED
Additional files submitted:
STM32+Primer2+Fimware+Develpment++PA1.pdf
Posted In:C/C++ElectronicsMicrocontrollerScientific Research |
Related projects:
Firmware Development - STM32 Primer2
mited to the necessary extent:
- Electronic advice, design and verification with regards to SMT32 Primer2
The following activities may be extended to the necessary extent:
- Advice on electronic design and verification with regards to replacing SMT32 Primer 2 with SMT32 Primer1
- Advice on electronic design and verification with regards to replacing the SMT32
Primer2 with an Atmel AVR based solution
... DETAILED PROJECT DESCRPTION ATTACHED
- Electronic advice, design and verification with regards to SMT32 Primer2
The following activities may be extended to the necessary extent:
- Advice on electronic design and verification with regards to replacing SMT32 Primer 2 with SMT32 Primer1
- Advice on electronic design and verification with regards to replacing the SMT32
Primer2 with an Atmel AVR based solution
... DETAILED PROJECT DESCRPTION ATTACHED
Firmware Engineer - Sunnyvale, CA - Must be local
oficient with Microsoft Word, Excel and PowerPoint
• Excellent written and oral communication skills
• Compensation: Dependent on Experience; potential for equity at early stage and joining company if mutually interested
• Principals only. Recruiters, please don't contact this job poster.
• Please, no phone calls about this job!
• Please do not contact job poster about other services, products or commercial interests.
• Excellent written and oral communication skills
• Compensation: Dependent on Experience; potential for equity at early stage and joining company if mutually interested
• Principals only. Recruiters, please don't contact this job poster.
• Please, no phone calls about this job!
• Please do not contact job poster about other services, products or commercial interests.
Car DVD Wince 5.0 firmware development
ith Chinese OS system (it run on WINCE 5.0)
We would like to develop a beautiful GUI with our specification features
Developer can modify chinese firmware or create new one
Car dvd have
Bluetooth
DVD
CD
SD
USB
Aux videos and anothers features
Have somebody here can work with firmware + GUI on car dvds products
We would like to develop a beautiful GUI with our specification features
Developer can modify chinese firmware or create new one
Car dvd have
Bluetooth
DVD
CD
SD
USB
Aux videos and anothers features
Have somebody here can work with firmware + GUI on car dvds products
USB firmware design
ck;width: 540px">
Looking for embedded software development services for interfacing peripherals like mouse (pointing device) and keyboard.
Extensive experience with microcontrollers, firmware development covering design and development in C, embedded C, C++, and protocols RS232, USB, UART mandatory.
Special interest in USB device firmware and host driver development a plus.
URGENT
Extensive experience with microcontrollers, firmware development covering design and development in C, embedded C, C++, and protocols RS232, USB, UART mandatory.
Special interest in USB device firmware and host driver development a plus.
URGENT
CSR Bluelab - Firmware development
We are using a Bluetooth firmware solution provided by CSR and we need to adapt the SBC decoder module to work properly with I2S slave mode audio. The module works with I2S master and the internal CODEC but needs modification to work with I2S slave.
Please DO NOT apply unless you have experience with, and access to, CSR BlueLab- including programming the Kalimba processor.
Please DO NOT apply unless you have experience with, and access to, CSR BlueLab- including programming the Kalimba processor.
Transportation Systems Development
atic systems which more details will be given at selection.
Outsource provider must have knowledge of Automobile, Aerospace, and Transportations systems to understand the scope of work.
Budget Range 25,000 euro – 30,000 euro for completed systems. Our company will require complete confidentiality, and also a legal contract for services outsourced. We will ask the contract be accompanied by a scanned picture ID (Legal ID w/ Name and Address)
Outsource provider must have knowledge of Automobile, Aerospace, and Transportations systems to understand the scope of work.
Budget Range 25,000 euro – 30,000 euro for completed systems. Our company will require complete confidentiality, and also a legal contract for services outsourced. We will ask the contract be accompanied by a scanned picture ID (Legal ID w/ Name and Address)
Firmware Development (Research Phase)
ngineers which can come up with a plan to develop High Quality software for these media devices. These media devices are based on Sigma chips(http://www.sigmadesigns.com) so knowledge about these chips are a pre. Experience in device programming is also pre.
For further device specifications please read the following websites:
- http://www.ebluetimes.com/en/productshow.asp?id=202
- http://www.egreatworld.com/en/ProductShow.asp?ID=118
For further device specifications please read the following websites:
- http://www.ebluetimes.com/en/productshow.asp?id=202
- http://www.egreatworld.com/en/ProductShow.asp?ID=118
Microchip Firmware Development TCP/IP Stack
ations using SMTP email protocol
• Users show the status using HTTP webpages
• SNMP Agent generate traps to the predefined PC
The code will be fully documented.
The code will be in C.
The last stack will be used.
The compilator will be MCC18.
The webpages will be provided.
• Users show the status using HTTP webpages
• SNMP Agent generate traps to the predefined PC
The code will be fully documented.
The code will be in C.
The last stack will be used.
The compilator will be MCC18.
The webpages will be provided.
Embeded and Labview skills
r>Kit will includes 50 different experiments in different theme and skill levels.
GUI will based on Labview software and will enebale user to monitor basic values from bread board and enable to controll basic proceedures for each experiments.
Bsic skills needed :
- USB Micro's with hardware, firmware development.
- Labview software for Gui
GUI will based on Labview software and will enebale user to monitor basic values from bread board and enable to controll basic proceedures for each experiments.
Bsic skills needed :
- USB Micro's with hardware, firmware development.
- Labview software for Gui
verifone software
looking for an experienced developer for VeriFone & Ingenico POS machines
must have experience with Processing Systems
32bit ARM and 8bit latest 8052 processors based embedded systems design and development and software/firmware development
must have experience with Processing Systems
32bit ARM and 8bit latest 8052 processors based embedded systems design and development and software/firmware development
POST firmware development for Atmega board
P.O.S.T. C code routines for a board with an Atmega128, AT45DB041D, DOGM163W-A LCD (ST7036 controller),DS1339C RTC, 3x3 keypad, 1 ADC and I/O.
STM32 Firmware Project
in a main.c file which will do a couple of simple things such as "Draw a Circle, Display a Number, Display a Bitmap File". Obviously this project should have access to the appropraite GUI and Standard Libraries
http://www.ebay.co.uk/itm/7-Touch-Panel-SSD1963-TFT-LCD-Module-STM32-Dev-Board-/200641684729?_trksid=p5197.m7&_trkparms=algo%3DLVI%26itu%3DUCI%26otn%3D2%26po%3DLVI%26ps%3D63%26clkid%3D6390791251013557688
http://www.ebay.co.uk/itm/7-Touch-Panel-SSD1963-TFT-LCD-Module-STM32-Dev-Board-/200641684729?_trksid=p5197.m7&_trkparms=algo%3DLVI%26itu%3DUCI%26otn%3D2%26po%3DLVI%26ps%3D63%26clkid%3D6390791251013557688
Web And E-commerce Development
uire the services of candidate who is fluent with the development and maintenance of a web site (and e-commerce) that contains approx. 15-20 pages. The candidate must be proficient with web development languages and the relevant database platforms. The site will require the user to select products for purchase, each product has 4-5 features that need to be selected, once the product has been added to the cart the user will pay for the item/s online and check out. A basic, standard web site.
Programmer For Fixes/development On Custom Joomla Program
Hey Everyone,
We are looking to bring on a programmer to do ongoing work helping us do bug fixes and development on a very custom Joomla Application. Also, some WordPress work as well.
This will be ongoing work for at least 2 years.
We are looking to bring on a programmer to do ongoing work helping us do bug fixes and development on a very custom Joomla Application. Also, some WordPress work as well.
This will be ongoing work for at least 2 years.
Very Intense Magento Development
Very intense Magento development
Android / Iphone Game Development - Unity3d - C#
have this product in a ready for market, bug FREE state no later than August 15th, 2012. Due to the quickly approaching deadline, we expect our development teams to work 6 days per week until the completion of all milestones has been reached to our satisfaction. A bonus will certainly be provided at our sole discretion if the project is completed ahead of schedule and above our expectation.
We look forward to working with you! Work begins on Thursday, May 10th. Good luck.
We look forward to working with you! Work begins on Thursday, May 10th. Good luck.
Software Development
We need someone with Software Development Experience to develop a standalone micro software(MS Word Macro Type Product).
Android methodology development process
st approach for the a mobile application methodology is. There are a lot of methodology out there such as RAD, Sprint, Scrum, Wataterfall etc so if anyone could explain only one of this that suit our development then please contact us ASAP. This project doesn't need long and lot of pages but between 1-2 is good enough. This project need to be done in a day.
Please contact or message me if anyone could do this project right away.
Please contact or message me if anyone could do this project right away.
Android methodology development
reat details and choose what is the best approach for the a mobile application methodology is. There are a lot of methodology out there such as RAD, Sprint, Scrum, Wataterfall etc so if anyone could explain only one of this that suit our development then please contact us ASAP. This project doesn't need long and lot of pages but between 1-2 is good enough.
Please contact or message me if anyone could do this project right away.
Please contact or message me if anyone could do this project right away.
Seo/web Development
NET GENERATION is a company which provides internet marketing solutions to customers worldwide. The company offers Web Designing, Web Development, SEO services, Commercial Web Design, E-Shopping Websites, Web promotions, Web marketing, Business marketing, Pay per click and other internet related services.
